These parts are sold for OFF ROAD, RACE-ONLY, ground-vehicle use only in a controlled environment. Moates prohibits the use of these products on emission controlled vehicles. California (CARB) & other states prohibit the sale or use of some aftermarket parts, including those that tamper with, modify or defeat emissions systems in any 1966 and newer vehicles. OFF ROAD USE NOTICE: items sold through including tuning products may be designed for off-road/race use only, and are not applicable for vehicles in states that require pollution controlled vehicles.
![aldl cable aldl cable](https://aws1.discourse-cdn.com/arduino/original/4X/9/f/6/9f6054a86bec33fc08029b3b3ca26d9edfb758a0.png)
#Aldl cable drivers
Later TBI, LT1 and TPI applications use 8192 baud which requires the switch to be in the ”open between A-B” position.Support Links Troubleshooting: Switches Datalogging with an ALDU1 WinALDL Software TunerPro V5: Converting ADS to ADX format GM 94-95: Reflash or not? GM 86-95 OBD1 Guide (READ ME) USB Drivers – FTCLEAN Troubleshooting: USB Drivers 101 USB Driver Installation ALDU1 Older applications that use 160baud require the ”10k across A-B” setting. If you have trouble connecting, check the switch on the ALDU1.If you are NOT using TunerPro RT, you should be able to start your software of choice and configure it to use the COM port of your ALDU1 (COM2 in this example).You will NOT get a positive test if the cable is plugged in to the vehicle. IF THE ALDU1 IS UNPLUGGED FROM THE VEHICLE, you should be able to click the “Test For Valid Interface Using Settings” button and get a successful result.Make sure that “Standard Serial” is selected (green arrow) and the COM port of your APU1 is selected (blue arrow).Then click the “Configure Plug-in Component” box (green arrow).Make sure “TunerPro Data Acquisition I/O Interface” is selected under the component drop down box. (red arrow) Make sure that “Use Plug-in” is selected for Interface Type. Next, make double check TunerPro’s configuration for logging.If you’re not using TunerPro, skip to step 8 below. Your ALDU1 will NOT be recognized by TunerPro RT software like an Ostrich or APU1. We’re going to walk through the TunerPro RT configuration steps to use this mode.Consult the instructions above for ‘Basic Connectivity’ for more detailed instructions. It will be necessary for you to know which COM port the ALDU1 is using to configure it properly.
#Aldl cable Pc
Make sure the ALDU1 is connected to your PC and has a COM port between 1 and 8.With that said, follow these instructions to get everything set up:
![aldl cable aldl cable](https://i.ebayimg.com/images/g/11wAAOSwEx5gWb8F/s-l225.jpg)
The best place to find these is the Definitions section of TunerPro’s website.
#Aldl cable free
Turn on the computer you want to use with the APU1 and plug the APU1 in to a free USB port.The first step in getting the AutoPROM working is to get your PC to recognize it. It uses the same FTDI drivers that all of our other products use. The ALDU1 uses a USB connection to talk to your PC. It allows your PC to communicate with your ECM.
![aldl cable aldl cable](https://s3.manualzz.com/store/data/030157574_1-129f88051ee6b75a714cd9b30a2373d9-360x466.png)
It attaches to the USB port of your PC and to the ALDL logging port on your vehicle.